Eurooptic vortex burris nightforce sale




teslong borescope digital camera barrel monitor


As an Amazon Associate, this site earns a commission from Amazon sales.









December 8th, 2012

Wind Reading Tips for F-Class and Long Range Shooting

by Steven Blair, 2012 California State Long Range F-Open Champion

Assess the Terrain and How the Wind Will Interact with It
Before you begin a match, take a few minutes to look around the range at the terrain, any obstructions, range topography (berms and backstop), and trees, buildings or structures that could affect wind flow over the range. Imagine what might happen if the wind was from the left or right, headwind or tailwind. Depending upon the direction, significant effects may be seen on range. A head or tail wind may ripple across the berms, causing elevation changes, both high and low. A tall side berm, like the east side berm at Ben Avery, may cause turbulence when the wind comes from that direction. Blocking features might shield most of the wind but a break along the range can funnel strong gusts through the gap with no other indications. Take a few notes about the effects of different wind directions and refer to them if the prevailing direction changes. (Tip courtesy Tony Robertson.)

Steven Blair F-Class Wind Tips

Use a Spotting Scope, Even When Shooting a Scoped Rifle
A good spotting scope can “see” mirage much more clearly than even an expensive rifle scope. Take your spotting scope to the line and position it as sling shooters do, close enough to use without much movement. Focus the scope approximately 1/3 of the way down range or where the most significant wind effects are likely to occur. Take a quick look while waiting for pit service, glance at the flags and compare to your scope sight picture. I often see ambiguous indications at the target through the rifle scope, but see a clear indication of wind direction and speed through the spotting scope at the shorter distance. When shooting the Arizona Palma Championship at Ben Avery last weekend, I was scoring while the wind was coming from the east. Shooters up and down the line were out to the left, losing points. Mirage at the target looked moderate and the flags weren’t indicating strong wind. As I focused the spotting scope back, the mirage suddenly looked like it was flowing twice as fast around 500 yards than it was closer or farther. It wasn’t until I realized that the access road cut through the berm there that I understood what was happening. (Tip courtesy Gary Eliseo.)

Steven Blair F-Class Wind Tips

Don’t Over-React to Something That May Be an Anomaly
On ranges with sizable berms, a headwind or tailwind can cause significant elevation problems. It is generally not possible to see or predict when this will occur. When the conditions exist that cause elevation changes and other competitors are experiencing the same problem, the best strategy is to ignore it. Certainly, avoid shooting when the head or tail wind is gusting, the same as you would in a crosswind. But, if you react to random, range-induced elevation changes, the only likely result is to make it worse. Whether the problem is caused by range or ammunition, maintain your waterline hold until you have evidence that something has fundamentally changed.

Steven Blair F-Class Wind Tips

My .284 Shehane will usually require a click or two down during a string as the barrel warms. That is normal and manageable. But, if your shots are just bouncing up and down in the 10 ring, leave it alone. The same is also true of an occasional gust pushing a shot into the 9 ring. If the conditions have not changed and one shot just went out, it may be the result of a random occurrence that was not predictable. (Tip courtesy “School of Hard Knocks”.)

Adjust Spotting Scope Focus and Magnification as Needed to View Mirage vs. Target Details
In F-Class we only need to see mirage, spotters, and scoring disks. That does not take a lot of magnification. My scope is a Nikon 25-75x82mm ED. It is a superb scope for the money and makes it trivial to see minor variations in mirage. It is good to have the high magnification available, and it can always be reduced if necessary. I use different power settings for different situations.

Steven Blair F-Class Wind TipsSetting Magnification Levels
During a match, in very good viewing conditions, I set my spotting scope at 75X, full power. The mirage is more subtle in the morning and greater magnification is needed.

During a match with heavy mirage I set my spotting scope at about 40X. I have no problem seeing mirage, even at this magnification.

When practicing at 300 yards or closer I set my spotting scope at max power (75X) so I can see the little 6mm holes from my 6BR rifle. I usually need to focus back and forth between shots to see both bullet holes and mirage.

Steven Blair, 2012 California State Long Range F-Open Champion, has been shooting since childhood and competing for over 30 years. Before retiring, Steve spent 16 years in Engineering and IT with General Atomics. He has held Engineering and Marketing positions with several firearms companies and worked on projects from pistols to 155mm howitzers.

Permalink Competition, Shooting Skills 3 Comments »
December 8th, 2012

Good Deal: MidwayUSA Competition Shooting Mat for $29.99

The MidwayUSA Competition Shooting Mat is on sale for just $29.99, forty bucks off the regular $69.99 price. The $29.99 sale price is good now through December 31, 2012. Sized 67″ Long x 27″ Wide, this mat rolls up into a 6.5-inch diameter “sausage” for transport or storage. While we prefer a wider mat (with more room for ammo boxes and shooting accessories), this mat has many nice features. Grommets on the corners allow the mat to be staked down in high winds. The mat has rubberized elbow and knee pads, and it comes with both a carry handle and a convenient shoulder strap.

prone shooting mat

This would be a useful, inexpensive holiday gift for a junior shooter, or anyone who needs a basic mat for High Power, tactical, or F-Class competition.

  • Material: 600 Denier PVC Coated Polyester
  • Unrolled Dimensions: 67″ Long x 26-3/4″ Wide (not including front flap)
  • Rolled Dimensions: 6-1/2″ Diameter x 26-3/4″ W
  • Elbow Pad Dimensions: 22-1/2″ Long x 25-1/2″ Wide
  • Knee Pad Dimensions: 12-1/2″ Long x 7″ Wide
  • Front Flap Dimensions: Tapers from 27″ to 48-1/2″ wide extending 11-1/2″ from front of mat
  • Padding Thickness: Roughly .25″ thick, plus .335″ thick at the elbow and knee pads
Permalink Hot Deals 1 Comment »