March 21st, 2019

Into the Wild — Visions of the Backcountry

Nightforce rifle scope photo

Here are some great rifle-centric outdoor photos courtesy of Nightforce Optics. Perhaps these “gunscapes” will encourage you to grab your rifle and head out into the wilderness this weekend. These images are part of an ongoing series of rifle photos posted on the Nightforce Facebook page. Can you identify the optics, and any of the locations?

These notable images remind us of the lure of the great outdoors for a rifleman. Going for a range session or taking your rifle on a game hunt gives you a chance to experience the grandeur of America’s mountains and wild backcountry.

Nightforce rifle scope photo

Nightforce rifle scope photo

Nightforce rifle scope photo

Nightforce rifle scope photo

Nightforce rifle scope photo

Nightforce rifle scope photo

Nightforce rifle scope photo

Nightforce rifle scope photo

Permalink - Articles, Optics No Comments »
March 21st, 2019

TEN Worst Reloading Mistakes — Do You Agree with This List?

Shooting Times Reloading Failures Mistakes Top Ten 10

Last fall, Shooting Times released an article entitled “Ten Most Common Reloading Mistakes”. Listed below are the Top Ten mistakes hand-loaders can make, at least according to Shooting Times. What do you think of this list — does it overlook some important items?

Top Ten Reloading Mistakes According to Shooting Times:

1. Cracked Cases — Reloaders need to inspect brass and cull cases with cracks.

2. Dented Cases — Dents or divets can be caused by excess case lube.

3. Excessive Powder Charge — Overcharges (even with the correct powder) can be very dangerous.

4. Primers Not Seated Deep Enough — “High” primers can cause functioning issues.

5. Crushed Primers — Some priming devices can deform primers when seating.

6. Excess Brass Length — Over time, cases stretch. Cases need to be trimmed and sized.

7. Bullets Seated Too Far Out — If the bullet is seated too long you may not even be able to chamber the round. Also, with hunting rounds, bullets should not engage the rifling.

8. Burrs on Case Mouths — Ragged edges on case mouths can actually shave bullet jackets.

9. Excess Crimp — This is a common problem with pistol rounds loaded on progressives. If case lengths are not uniform some cases will get too much crimp, others too little.

10. Inadequate Crimp — This can be an issue with magnum pistol cartridges in revolvers.

Do you agree with this list? We think some important things are missing, such as not adjusting full-length sizing dies properly. This can cause the shoulder to be pushed back too far (or not far enough). Another common mistake is using brass that is worn out, i.e. stretched in the case-head area from multiple cycles of hot loads. We also think the #1 error a reloader can make is using the wrong powder altogether. That can be a fatal mistake. See what happens when you load pistol powder in a rifle.

Permalink Bullets, Brass, Ammo, Reloading 9 Comments »
March 21st, 2019

Proper Sight Picture with Various Types of Sighting Systems

NRA sight picture alignment video

As part of the NRA Mentor Program, the NRA offers a helpful video about using sights. This covers all types of sighting systems — blade sights, aperture sights, V-notch sights, red dot sights, shotgun bead sights, and telescopic sights with reticles. For new shooters, this video can be helpful — it explains sight basics in very clear and comprehensible terms. And even for experienced shooters, this can provide some helpful tips on sight alignment, particularly when shooting pistols.

Additional information about using sights is contained in the NRA’s free Guide for New Shooters. This helpful 14-page digital publication provides the key firearms safety rules, explains range etiquette, and even has a section on gun cleaning. CLICK HERE to download Guide for New Shooters.

NRA sight picture alignment video

Training With Lasers — Trigger Control
Training with laser sights helps diagnose and improve trigger control errors by showcasing the importance of “surprise break” and follow-through. Working with gun-mounted lasers, which put a red or green dot right on the target, can quickly diagnose errors such as recoil anticipation, jerking the trigger, and breaking the wrist. This video shows how handgunners can use pistol-mounted lasers to correct bad habits and shoot more consistently.

Permalink - Videos, Handguns, Shooting Skills No Comments »