September 23rd, 2019

Quick-Release Mirage Shield with Front/Rear Attachments

mirage shield tab hook barrel mount urban rifleman

Forum member UrbanRifleman is a talented parts designer and 3D-printing specialist who has developed a series of useful products for shooters. One of the cool items UrbanRifleman produces is a quick-release “snap-on” mirage shield. The shield has tabs on each end. These tabs snap into plastic fittings front and rear. Here’s a video showing how it works:

The mirage shield attaches via front and rear quick-release fittings. In the back there’s a rail-mounted hook. In the front, at the muzzle end, is a 3D-printed ring clamp that fits the barrel precisely. These muzzle rings are tailored to the barrel diameters in a variety of diameters: 0.625″, 0.75″, 0.85″, 0.90″, 0.95″, 1.0″, 1.25″, and 1.50″. The front barrel-end clamp it shown at top. Below is the rear attachment, mounted on the Picatinny-type scope rail.

mirage shield tab hook barrel mount urban rifleman

Satisfied Customer Praised this Shield Kit
One of our Forum members recently bought this quick-to-attach Mirage Shield and was very impressed: “I bought the Snap-on Mirage Shield from UrbanRifleman for my F-Class rifle. It worked so well I just ordered two more. Not only does it work well, it gets rid of the ugly and looks professional.” — BigJohn

You can order the Mirage Shield from UrbanRifleman on the Forum. The cost for the kit, which includes the Mirage Shield attachment fittings, is $29.00 for one or $50.00 for two units. As noted, the rear fitting clamps to a standard Picatinny-type scope rail. Up front is a plastic mount that clamps around the end of the barrel. You’ll need to specify your barrel diameter. You can see more photos on eBay, where you can purchase direct.

mirage shield tab hook barrel mount urban rifleman

The Kit includes all parts needed to assemble a Picatinny-mounted mirage kit:

(1) Barrel-end front clamp with hardware (specific to barrel diameter)
(1) Picatinny rear mount with hardware
(1) Elastic Mesh 3″ x 30″ long
(2) Hangars
(2) Hooks

NOTE: This kit requires some assembly. Cut mesh to length, allowing for a few inches of stretch. Cut the ends square and glue them into the hangars with Elmer’s glue or similar adhesive. Then tape and let dry.

Similar Posts:

Tags: , , , , ,