Comments on: Build Your Own Target Stand with Inexpensive PVC or ABS Pipe

By: BobA

BobA — Thu, 31 Jan 2019 16:11:05 +0000

Paint the PVC pipe to prevent UV rot. It takes months for the PVC to become brittle, but it will. Cheap white primer is what I use. This goes for black or white PVC.

By: SMB

SMB — Sun, 29 Jul 2018 23:44:09 +0000

Hook and loop fastener adhesive tape and core-flute board for target backer. Waterproof, wind proof and you can change the whole backer with pre-stapled targets in 10 seconds

By: Randy Scott

Randy Scott — Wed, 25 Jul 2018 09:42:19 +0000

I added two tees on the base for storing the vertical pieces when not in use. The whole stand goes right behind my seat in my civic.

By: Rich Kayser

Rich Kayser — Wed, 25 Jul 2018 06:39:26 +0000

I built one this spring. I used sand to weigh the bottom cross braces. Stands very well in our wind.

By: Joe

Joe — Tue, 24 Jul 2018 20:09:10 +0000

Save some materials and improve the lifespan of the stand by shortening the upright 24″ pipes.

6″ is more than enough.

If you cut all the horizontal pieces to 18″, the uprights to 6″, you only consume one 10′ stick of pipe and your onsite setup is simplified since all the horizontal pieces are interchangeable.

By: jrd2176

jrd2176 — Tue, 24 Jul 2018 18:05:01 +0000

They are 90 degree elbows.

By: Pete Roberson

Pete Roberson — Fri, 17 Feb 2017 21:27:40 +0000

Would like to see all the pipes assembled in a video, Please!
The 45* corners may not work ?