https://bulletin.accurateshooter.com/2024/01/how-to-blueprint-a-rem-700-action-rifleshooter-com-report/ from AccurateShooter.com Tue, 11 Aug 2026 16:28:08 +0000 hourly 1 https://wordpress.org/?v=4.1.26 https://bulletin.accurateshooter.com/2024/01/how-to-blueprint-a-rem-700-action-rifleshooter-com-report/comment-page-1/#comment-61265 Wed, 17 Jan 2024 17:32:09 +0000 http://bulletin.accurateshooter.com/?p=69785#comment-61265 This article never mentions extraction timing. With minimal removal you might not lose enough extraction to be a problem, maybe!! With magnums you can never have enough extraction!! Good luck!

]]> https://bulletin.accurateshooter.com/2024/01/how-to-blueprint-a-rem-700-action-rifleshooter-com-report/comment-page-1/#comment-61256 Thu, 11 Jan 2024 23:59:07 +0000 http://bulletin.accurateshooter.com/?p=69785#comment-61256 A tap will clean up the threads but it is not going to change the alignment. The only way to fix the alignment is single point on a lathe.

]]> https://bulletin.accurateshooter.com/2024/01/how-to-blueprint-a-rem-700-action-rifleshooter-com-report/comment-page-1/#comment-61249 Tue, 09 Jan 2024 16:30:36 +0000 http://bulletin.accurateshooter.com/?p=69785#comment-61249 If an action is not too far out, this can work, but for those that are beyond the reach of the oversized tap (which is typically .010 oversized), single pointing the threads on a lathe is the preferable option, because that method allows you to fully clean up the threads. A long time ago a friend was having issues with a Remington. It turned out that he had to open the threads .025 to get them to clean up on axis.

]]>