AccurateShooter Forum member Brett M. from Minnesota (aka Spitfire_er) recently completed a handsome laminated maple gunstock. This beauty wasn’t produced with a stock duplicator. It was made the old-fashioned way — by hand. After laminating three sections, Brett carved the complete stock with hand tools. You can see the entire carving process, start to finish, in Brett’s time lapse video.

MUST-SEE time-lapse carving video. Every second is one minute in real time. This 15:54 video shows 15.9 hours of carving! Brett says the whole job took nearly 20 hours:

Handsome Maple Blank Was Lumber Yard Return!
Brett reports: “Here’s a stock I carved up over the past year or so. I found this wood as a return at a lumber yard about 7-8 years ago. I asked the guy in the yard about it and he said it had been returned because it had too much figure for the job the customer was working on. First thing I thought was “That would make a nice stock!” I finally got around to finishing it a couple months ago.

I fit it around a 1917 Enfield in .338 WM that I purchased a while back. I usually do all the work on the receiver and barrel, but this one was done up in an OK fashion already.

This stock was almost completely made using hand tools over the course of about a year. This is a piece of laminated 1x8x1″ maple that was glued together. After it sat for about eight years, I finally got around to carving it up. This stock design/shape was from my own ideas and was carved as I went along. It turned out pretty good.”