PMA Micro-Adjust Case Trimmer — Precise and Handy

Serious reloaders know that PMA Tool makes some of the best specialty reloading tools you can buy. To help folks get the most out of their PMA products, the company offers “how-to” videos. One such video features PMA’s great Micro-Adjust Case Trimmer. PMA owner Pat Reagin tells us: “We’ve had quite of bit of interest in the case trimmer, but a lot of guys want to see it in action. So we’ve created an intro video that shows how to adjust and use the trimmer in various modes.”

Watch Micro-Adjust Case Trimmer Video

The PMA Micro-Adjust Case trimmer indexes off the shoulder but it also provides precise control over neck length. You aren’t limited to a built-in, neck-length setting like some other shoulder-indexed trimmers. The PMA Micro-Adjust Trimming tool currently sells for $129.95 including one cartridge insert. The inserts, which can be purchased for $13.95 separately, can often work for a multiple cartridge types within the same family. For example, you can use the same insert for both .243 Win and .260 Rem. There is another insert that works with both 7mm-08 and .308 Win.

PMA Micro-Adjust Case Trimmer Features:

• Indexes off shoulder for easy, consistent trim length.
• Cases captured in no-scratch, Delrin™ inserts.
• Fully rotating head with bearing for smooth operation and clean, square cuts.
• Sharp carbide cutter for quick, smooth cuts with minimal burr.
• Spring loaded head allows complete control of rate of feed.

How to use the PMA Micro-Adjust Case Trimmer
The trimmer indexes case off the case shoulder through the use of interchangeable Delrin™ inserts which capture the shoulder and neck of the case. This insert is contained in a spring-loaded tool head that rides on a linear bearing. The Micro-Adjust Trimmer can be used in three ways.

First, you can secure the case in a PMA caseholder chucked in a power drill, drill press, or lathe. You hold the trimming tool with your hand and feed in the spinning case. (This method is handy because if you leave the case in the holder, after you have trimmed to length, you can switch tools and chamfer the case-mouth using the same power source).

In the second method, the trimmer’s adjustment knob is removed (after locking the setting) and the cutting shaft is chucked in a drill, drill press. or lathe. Using this method, the case itself is held by hand and fed into the cutter. Lastly, the trimmer can be used manually, holding the case in one hand and the trimmer in the other. That’s the slowest method, but it works if you do not have power tools handy.