Tuning Tips — Pressure, Powder Fouling, and Temperature
by Tommy Todd, Sierra Bullets Chief Ballistician for Sierra Bullets Blog
I have shot several disciplines of shooting competitions over the years and have learned a few things regarding ammunition and bullet function during this time. Frequently the matches I shoot require 40 to 100 shots before a person gets a chance to clean his rifle. Just as frequently, a good shooting match rifle will still shoot very good scores and groups with that many rounds fired through them. However, those guns do not deliver the same accuracy as when they were clean, but the drop-off in accuracy is not a huge change unless a set of accumulative issues arise.
In one situation, very dirty powder created more serious problems…
Pressure Issues — Extraction Problems Caused by Bad Fouling
Problem: Pressures Increased as Powder Fouled Barrel and Carbon Ring Formed
Solution: Clean Barrel Every Ten Rounds.
I witnessed a set of problems that occurred with a fellow competitor’s rifle at a recent F-Class match. He was using a large case capacity cartridge for the bore diameter and he was shooting a powder that was burning extremely dirty. As the match progressed, the carbon buildup caused most likely a carbon ring in the throat of the rifle and pressures kept increasing to the point that the cases were hard to extract, bolt lift was excessive, and eventually he quit shooting the rifle due to these issues. Accuracy also suffered as could be evidenced by the gun’s performance on target. This load looked fine when he was developing it, none of the excessive pressure signs appeared when he worked the load up, but he was cleaning the gun every ten shots.
When he was shooting multiple, 20-shot strings during the match is when the issues appeared. He was able to give the gun a thorough cleaning and the issues went away, for several rounds and then the pressures started appearing again. These pressure signs were not due to ambient temperatures as it was a cool spring morning and the temperature was in the low 40° range.
Accuracy Issues — Tune Lost with Higher Ambient Temps
Problem: Accuracy Lost When Outside Temp Much Hotter than When Load Developed
Solution: Pull Bullets, Reload Ammo with Lighter Charge
A couple of years ago, I attended a match early in the shooting season and it was unusually hot for that time period. I heard a competitor worrying before the match about his gun “blowing up”. At first I was concerned, but after thinking about what he had said I realized that he meant his “accuracy” blowing up, meaning he knowingly had loaded his ammunition at the top end of an accuracy tune that he established via a ladder test. The next day I asked him how his scores were and he said the gun was not shooting very well initially, but he had found enough equipment from friends that were at the match and had pulled the bullets, reduced the powder charge by a few tenths of a grain and re-seated the bullets and his gun was now shooting normally. The temperature difference between his home range the weekend before when he established his load and the match conditions was about 30 degrees and that was enough to cause an accuracy change at 1000 yards.
For example, barrel temperature was a key factor: “Both barrel temperature and powder temperature are important variables, and they are not the same variable. If you fail to take barrel temperature into account while doing pressure testing, your test results will be very significantly affected. The effect of barrel temperature is around 204 PSI per F° for the Varget load. If you’re not controlling barrel temperature, you about as well might not bother controlling powder temperature, either. In the cases investigated, barrel temperature is a much stronger variable than powder temperature.” |
To learn more about how ambient temperature (and primer choice) affect pressures (and hence velocities) you should read the article Similar Posts:
- Tech Tip: Keep Your Ammo Cool this Summer
- Effects of Heat on Powder Performance
- Smarter Shooter: Keep Your Ammo Cool on Hot Summer Days
- Beat the Heat: Keep Your Ammo Cool in Summer
- Don’t Roast Your Ammo — Watch Temps in Hot Summer Months
Share the post "Tuning Tips — Pressure, Powder Fouling, and Temperature"
Tags: Barrel Heat, Carbon Ring, Powder Fouling, Pressure Trace, Rising Pressure, Sierra Bullets, Temperature
