Case Trimmer “How-To” Videos from L.E. Wilson

L.E. Wilson, makers of hand dies, case trimmers and other precision reloading tools, has released a series of informational videos. These videos show how to assemble and operate L.E. Wilson tools including the new Wilson stainless steel case trimmer with micrometer adjustment (photo below). The first video explains the operation of the Wilson trimmer and shows how to initially assemble the tool, attach the handle, and set the cut length.

This second video shows how to set up the new stainless Wilson trimmer with micrometer cut-length control. The new micrometer feature allows you to set the cartridge overall trim length with great precision. If you are trimming a variety of different cartridge types, the micrometer cut length control comes in very handy. In seconds you can “dial in” different trim lengths, without messing around with set screw or locking rings. Fine adjustment is in increments of .001″ is done with the the Micrometer. Gross adjustment is done with with the stop screw. If you go from a very short case to a very long case, you will need to reposition the stop screw. Note: In addition to the videos shown here, L.E. Wilson has a video showing how to mount a the trimmer assembly and case holder arm on a base.

KEY FEATURES of L.E. Wilson Stainless Case Trimmer with Micrometer:

• New long-lasting stainless finish with micrometer adjustment.
• New increased width on Stop Nut. This provides for a firm stop.
• Larger stop screw with Black Oxide Coating, adjustment from 3/8″ (old) to 1/2″.
• New 304 Stainless Steel Handle standard on all trimmers shipped after July 2013.
• Made in the U.S.A. with American steel.

Along with its case trimmer video, L.E. Wilson has produced three videos showing how to use Wilson cartridge case gages. This series of Case Gage Videos show how to use the gage to check headspace and properly set shoulder bump with a full-length sizing die.