How To Install a Scope on Your Hunting or Field Rifle
Hunting season is right around the corner. That means its time to inspect all your hunting gear, including your scope set-up. A proper scope installation involves more than just tensioning a set of rings — you need to consider the proper eye relief and head position.
In this NSSF video, Ryan Cleckner shows how to set up a scope on a hunting or tactical rifle. Ryan, a former U.S. Army Sniper Instructor, notes that many hunters spend a small fortune on equipment, but fail to set up their rifle to use the optics optimally. Cleckner likens this to someone who owns an expensive sports car, but never adjusts the seat or the mirrors.
Ryan notes that you want your head and neck to be able to rest naturally on the stock, without straining. You head should rest comfortably on the stock. If you have to consciously lift your head off the stock to see through the scope, then your set-up isn’t correct. Likewise, You shouldn’t have to push your head forward or pull it back to see a clear image through the scope. If you need to strain forward or pull back to get correct eye relief, then the scope’s fore/aft position in the rings needs to be altered. Watch the full video for more tips.
Video find by EdLongrange. We welcome reader submissions.Tips on Mounting Your Scope and Adjusting Your Comb Height:
1. Normally, you want your scope mounted as low as possible, while allowing sufficient clearance for the front objective. (NOTE: Benchrest shooters may prefer a high mount for a variety of reasons.)2. Once the scope height is set, you need to get your head to the correct level. This may require adding an accessory cheekpad, or raising the comb height if your rifle has an adjustable cheekpiece.
3. Start with the rifle in the position you use most often (standing, kneeling, or prone). If you shoot mostly prone, you need to get down on the ground. Close your eyes, and let you head rest naturally on the stock. Then open your eyes, and see if you are too low or too high. You may need to use a cheekpad to get your head higher on the stock.
4. If your scope has a flat on the bottom of the turret housing, this will help you level your scope. Just find a flat piece of metal that slides easily between the bottom of the scope and the rail. Slide that metal piece under the scope and then tilt it up so the flat on the bottom of the scope aligns parallel with the flats on the rail. Watch the video at 8:40 to see how this is done.
Similar Posts:
- Tech Tip: How to Mount a Scope for a Tactical or Hunting Rifle
- How to Properly Mount a Scope on a Hunting or Field Rifle
- Hunting 101: Mounting Your Hunting Optic
- Mounting a Scope Properly on Your Hunting Rifle
- Optics INFO: Mounting a Scope on Your Hunting Rifle
Share the post "How To Install a Scope on Your Hunting or Field Rifle"
Tags: Cleckner, hunting, Optics, Rings, Scope, Scope Level, Video
It’s a very big assumption to make that the flat bottom of the scope and the reticle align.
It’s certainly not been my experience over the last 40 years.
Regards
JCS
JCS – agreed. Plumb line at 100 yards works for me – along with a good level to make sure the scope rail is parallel to the ground before aligning the scope reticle to the plumb line.
Seen cross-hairs that were not square level to the scope body/turrets.
Seen actions that are not square to the stock.
From a leveled stock, vertical cross-hair to a plumb line at 100 yards is my way.
Everything else is a hypothetical.
This reminds me of the canted reticle in my $1K Leupold that the factory says is within spec…