Case Prep Tips from Western Powders

Western Powders (which sells Accurate, Ramshot, and Norma powders) has published an article on case inspection and preparation. There are many tips in this article that can be useful to precision hand-loaders. For example, every time you open a new box of cartridge brass (particularly from domestic makers), you should inspect each case for flaws.

TIP ONE: Visual Inspection — Finding Flaws
Cases are mass-produced items and malformed ones are relatively common. Inspect each case carefully looking for obvious defects. A bench-mounted magnifying glass with light is a real help for the over-40 crowd. The main defects will be cracks in the neck or case body, crushed shoulders or deep creases in the neck. Next check the primer pocket. It is also fairly common to find flash holes that are damaged or, more rarely, not concentric to the primer pocket.

Imperfections like small dings in the case body, or necks that are not completely symmetrical do not have to be eliminated at this step. Damage of this sort is usually from loose packaging and usually has not seriously damaged the brass. [Running an expander mandrel in the neck] and fire-forming will iron out these largely cosmetic issues.

The Western Powder article also talks about primer pocket uniforming. We do NOT normally uniform the pockets for Lapua or RWS brass from the start. However, pocket uniforming can be beneficial with some other brands of brass, including Lake City, Remington, and Winchester. If you shoot milsurp brass, set time aside for pocket uniforming.

TIP TWO: Primer Pocket Uniforming
Like flash holes, primer pockets are mass-produced and prone to small dimensional changes. A uniforming tool is used to make the depth of each primer pocket consistent. In turn this allows similar firing pin strike depths on the primer which creates more consistent ignition characteristics.

A good uniforming tool should have a shoulder, or another positive stop, that sets the cutter’s depth. Its use is pretty straightforward. The cutter is inserted into the pocket and turned clockwise several times until the stop in flush with the case head and no more brass is removed from the juncture of the pocket’s base and sidewall. This a job best done by hand. You will feel when the cutting is finished by a change in how smoothly the cutter turns in the pocket. Very little material is actually removed; usually just enough to square the radius at the bottom of the pocket.

Similar Posts:

• New 8-Piece Case Prep Tool Set from Lyman
• Inspect Your Flash Holes on New Brass
• Primer Pocket Gauge — Cool Tool Checks for Loose Pockets
• Check Primer Pocket Diameter and Depth with Handy Tools
• Check Your Primer Pockets with Handy Pocket Gauges

Tags: Case Prep, Hand-loading, Primers, Reloading, Western Powders