As an Amazon Associate, this site earns a commission from Amazon sales.











November 24th, 2020

6mm Creedmoor Load Data from Sierra Bullets + BONUS

6mm Creedmoor 6.5 Creedmoor load data Sierra Bullets
NOTE: The 6mm Creedmoor now does have an official SAAMI specification. It is no longer just a wildcat.

CLICK HERE for Sierra Bullets 6mm Creedmoor LOAD DATA PDF »

Sierra Bullets Load Data 6mm Creedmoor reloading tips

Sierra Bullets has published load data for the 6mm Creedmoor cartridge, a necked-down version of the popular 6.5 Creedmoor. Sierra has released very comprehensive 6mm Creedmoor load data, covering fifteen (15) different bullets from 55 to 110 grains. NOTE: Hornady-brand brass was used for Sierra’s 6mm Creedmoor load tests, not the newer, stronger Lapua 6.5 CM brass with small primer pockets. Hand-loaders using Lapua 6.5 Creedmoor brass necked to 6mm may have to adjust their loads.

Sierra writes: “As soon as the 6.5 Creedmoor was released in 2007, a 6mm version was being envisioned. After the 6mm Creedmoor demonstrated its worth at 1000 yards it began to catch the attention of Precision Rifle Series (PRS) competitors. The 6mm Creedmoor is a great fit for those looking for an AR platform-friendly cartridge. It delivers velocities very similar to the .243 Win and yet fits the AR10 magazine length[.] The 30-degree shoulder makes this a very efficient case and helps prolong case life as well. The 6mm Creedmoor works well with powders such as H4350, [RE-16], RE-17, and Ramshot Hunter for heavier long-range bullet weights. Slightly faster powders such as RE-15, Win 760, and Vihtavuori N540 work well with lighter weight bullets.”

Sierra Bullets Tested for 6mm Creedmoor Load Data
55gr BlitzKing (#1502)
60gr HP (#1500)
70gr HPBT (#1505)
70gr BlitzKing (#1507)
75gr HP (#1510)
80gr SBT (#1515)
85gr Spitzer (#1520)
85gr HPBT (#1530)
90gr FMJBT (#1535)
95gr HPBT (#1537)
95gr TMK (#7295)
100gr Spitzer (#1540)
100gr SBT (#1560)
107gr HPBT (#1570)
110gr HPBT (#1575)

In developing its 6mm Creedmoor load data, Sierra tested a very wide selection of propellants, two dozen overall. For the smaller bullets, fast-burning powders such as Benchmark, H4895, and CFE223 were tested. For the heavier 100+ grain bullets, Sierra tested a selection of medium-burn-rate powders including H4350, Reloder 16, Reloder 17, Varget, and Superformance. Sierra did a very thorough job. We know this information will be welcomed by 6mm Creedmoor shooters.

Don’t know what powder to try first? For the 107-110 grain bullets, if you want best accuracy and low ES/SD, our Forum members recommend Alliant Reloder 16 and Hodgdon H4350. If you are seeking max velocity with the 110-grainer, look at Hodgdon Superformance and Reloder 19.

Here are Sierra’s 6mm Creedmoor Load Data Charts for 90-95 grain bullets plus the 107gr MK and 110gr MK. There are five other tables for other bullet types.

6mm Creedmoor 6.5 Creedmoor load data Sierra Bullets

6mm Creedmoor 6.5 Creedmoor load data Sierra Bullets

6mm Creedmoor 6.5 Creedmoor load data Sierra Bullets

6mm Creedmoor 6.5 Creedmoor load data Sierra Bullets


BONUS: PRB 6mm Creedmoor and 6.5 Creedmoor Load Survey

The Precision Rifle Blog compiled Load Data from PRS Competitors, for both 6mm Creedmoor and 6.5 Creedmoor. This is a good place to start. PRB surveyed the match loads for “173 of the top-ranked precision rifle shooters in the country”. One cautionary note: These PRS guys may be loading fairly hot, so work up gradually, 0.3 grains at a time. CLICK HERE.

PRB precision rifle blog pet loads what pros use 6.5 Creedmoor 6mm CM

Permalink Bullets, Brass, Ammo, Reloading, Tactical No Comments »
May 7th, 2019

6mm Creedmoor — How Many FPS Will a Shorter Barrel Cost You?

6mm 6.5 Creedmoor rifleshooter.com Bill Barr barrel length cut-down velocity test chronograph Magnetospeed chrono

Our friend Bill Marr of Rifleshooter.com has done it again — conducted a fascinating 6mm Creedmoor barrel cut-down test that reveals how velocity changes with barrel length. This time Bill started with a 24″ Proof Research stainless steel barrel on a Howa action. Bill says this was a well-used barrel, with over 1800 rounds through it. So, the velocities might be a bit different than a new barrel of similar length. Bill cut the barrel down in one-inch increments. Here are some results from the test:

24″ Velocity: 2893 FPS | 20″ Velocity: 2755 FPS | 16.1″ Velocity: 2598 FPS

CLICK HERE for FULL TEST REPORT on RifleShooter.com »

6mm 6.5 Creedmoor rifleshooter.com Bill Barr barrel length cut-down velocity test chronograph Magnetospeed chrono

6mm 6.5 Creedmoor rifleshooter.com Bill Barr barrel length cut-down velocity test chronograph Magnetospeed chronoFor this latest test, Rifleshooter cut the barrel in one-inch increments from 24″ to 16.1″ (just over legal minimum). Velocities were measured with a MagnetoSpeed V3 chronograph mounted on arm attached to the stock. This allowed the chrono to be adjusted inwards as the barrel was cut shorter, inch by inch.

For the 6mm Creedmoor cartridge, Bill loaded Hornady 108gr ELD Match bullets over 41.5 grains of Hodgdon H4350 with CCI 200 primers in new Starline brass.

The results were interesting to say the least. Bill reports: “Muzzle velocities ranged from 2,893 ft/sec at 24″ to 2,598 ft/sec at 16″ for a decrease in muzzle velocity of 295 ft/sec. Muzzle velocity changes per inch of barrel length ranged from 6 ft/sec per inch between 20 and 19 inches to 63 ft/sec per inch between 19 and 18 inches. Average velocity change per inch of barrel length was 37.9 ft/sec.”

Bill concludes: “An average drop of 37.9 ft/sec/inch of barrel is fairly significant and is what would be expected with a fast moving 6mm cartridge like the 6mm Creedmoor. While I’m used to seeing 6mm Creedmoors with slightly longer barrel lengths than 24″, when coupled with a sound suppressor the additional length can make moving the rifle quickly more difficult.

I’d suggest staying with longer barrel lengths wherever possible with this cartridge. At shorter lengths, it does give up more performance than its big brother the 6.5 Creedmoor.”

More 6mm Creedmoor Velocity Data from 2017 Cut-Down Test

If you’re curious about 6mm Creedmoor velocities at longer barrel lengths, back in 2017 Rifleshooter completed a 6mm Creedmoor barrel cut-down test from 31 inches all the way down to 17 inches. The test included four bullet types from 95 grains to 110 grains. With the 110gr Sierra MK, velocity at 31″ was an impressive 3110 fps. Surprisingly the velocity didn’t decrease that much for the first few inches. Even at 26″ (a five-inch reduction), measured velocity with the 110s was 3073 fps, a loss of 7.4 fps per inch on average. With a barrel shortened all the way to 20″ however, velocity had dropped down to 2949 fps, a significant (161 fps) loss. CLICK HERE for complete results from that 31″-17″ Barrel Cut-Down Test.

6mm 6.5 Creedmoor rifleshooter.com Bill Barr barrel length cut-down velocity test chronograph Magnetospeed chrono

CLICK HERE for 31″ to 17″ 6mm Creedmoor Barrel Test Report »

Permalink - Articles, Bullets, Brass, Ammo, Gunsmithing, Tactical No Comments »