Try a club match this summer! Every summer weekend, there are hundreds of local club “fun matches” conducted around the country. One of the good things about club shoots is that you don’t have to spend a fortune on equipment to have fun. But we’ve seen that many club shooters handicap themselves with a few common equipment oversights or lack of attention to detail while reloading. Here are SIX TIPS that can help you avoid these common mistakes, and build more accurate ammo for your club matches.
1. Align Front Rest and Rear Bag
We see many shooters whose rear bag is angled left or right relative to the bore axis. This can happen when you rush your set-up. But even if you set the gun up carefully, the rear bag can twist due to recoil or the way your arm contacts the bag. After every shot, make sure your rear bag is aligned properly (this is especially important for bag squeezers who may actually pull the bag out of alignment as they squeeze).
Forum member ArtB adds: “To align my front rest and rear bag with the target, I use an old golf club shaft. I run it from my front rest stop through a line that crosses over my speed screw and into the slot between the two ears. I stand behind that set-up and make sure I see a straight line pointing at the target. I also have a piece of tape that I’ve placed on the golf shaft that indicates how far the back end of the rear bag should be placed from the front rest stop.”
2. Avoid Contact Interference
We see three common kinds of contact or mechanical interference that can really hurt accuracy. First, if your stock has front and/or rear sling swivels make sure these do NOT contact the front or rear bags at any point of the gun’s travel. When a sling swivel digs into the front bag that can cause a shot to pop high or low. To avoid this, reposition the rifle so the swivels don’t contact the bags or simply remove the swivels before your match. Second, watch out for the rear of the stock grip area. Make sure this is not resting on the bag as you fire and that it can’t come back to contact the bag during recoil. That lip or edge at the bottom of the grip can cause problems when it contacts the rear bag. Third, watch out for the stud or arm on the front rest that limits forward stock travel. With some rests this is high enough that it can actually contact the barrel. We encountered one shooter recently who was complaining about “vertical flyers” during his match. It turns out his barrel was actually hitting the front stop! With most front rests you can either lower the stop or twist the arm to the left or right so it won’t contact the barrel.
3. Weigh Your Charges — Every One
This may sound obvious, but many folks still rely on a powder measure. Yes we know that most short-range BR shooters throw their charges without weighing, but if you’re going to pre-load for a club match there is no reason NOT to weigh your charges. You may be surprised at how inconsistent your powder measure actually is. One of our testers was recently throwing H4198 charges from a mechanical measure for his 30BR. Each charge was then weighed twice with a Denver Instrument lab scale. Our tester found that thrown charges varied by up to 0.7 grains! And that’s with a premium measure.
4. Measure Your Loaded Ammo — After Bullet Seating
Even if you’ve checked your brass and bullets prior to assembling your ammo, we recommend that you weigh your loaded rounds and measure them from base of case to bullet ogive using a comparator. If you find a round that is “way off” in weight or more than .005″ off your intended base to ogive length, set it aside and use that round for a fouler. (Note: if the weight is off by more than 6 or 7 grains you may want to disassemble the round and check your powder charge.) With premium, pre-sorted bullets, we’ve found that we can keep 95% of loaded rounds within a range of .002″, measuring from base (of case) to ogive. Now, with some lots of bullets, you just can’t keep things within .002″, but you should still measure each loaded match round to ensure you don’t have some cases that are way too short or way too long.
5. Check Your Fasteners
Before a match you need to double-check your scope rings or iron sight mounts to ensure everything is tight. Likewise, you should check the tension on the screws/bolts that hold the action in place. Even with a low-recoiling rimfire rifle, action screws or scope rings can come loose during normal shooting.
6. Make a Checklist and Pack the Night Before
Ever drive 50 miles to a match then discover you have the wrong ammo or that you forgot your bolt? Well, mistakes like that happen to the best of us. You can avoid these oversights (and reduce stress at matches) by making a checklist of all the stuff you need. Organize your firearms, range kit, ammo box, and shooting accessories the night before the match. And, like a good Boy Scout, “be prepared”. Bring a jacket and hat if it might be cold. If you have windflags, bring them (even if you’re not sure the rules allow them). Bring spare batteries, and it’s wise to bring a spare rifle and ammo for it. If you have just one gun, a simple mechanical breakdown (such as a broken firing pin) can ruin your whole weekend.
Share the post "Six Tips for Success at Local Club Fun Matches"
Spring is almost here! This year Spring Equinox is March 20, 2022 — just 10 days away. That means local fun matches will start to be held at ranges across the country. Starting in the spring and running through early fall, there are hundreds of local club weekend “fun matches” conducted around the country.
One of the good things about club shoots is that you don’t have to spend a fortune on equipment to have fun. But we’ve seen that many club shooters handicap themselves with a few common equipment oversights or lack of attention to detail while reloading. Here are SIX TIPS that can help you avoid these common mistakes, and build more accurate ammo for your club matches.
1. Align Front Rest and Rear Bag
We see many shooters whose rear bag is angled left or right relative to the bore axis. This can happen when you rush your set-up. But even if you set the gun up carefully, the rear bag can twist due to recoil or the way your arm contacts the bag. After every shot, make sure your rear bag is aligned properly (this is especially important for bag squeezers who may actually pull the bag out of alignment as they squeeze).
Forum member ArtB adds: “To align my front rest and rear bag with the target, I use an old golf club shaft. I run it from my front rest stop through a line that crosses over my speed screw and into the slot between the two ears. I stand behind that set-up and make sure I see a straight line pointing at the target. I also have a piece of tape that I’ve placed on the golf shaft that indicates how far the back end of the rear bag should be placed from the front rest stop.”
2. Avoid Contact Interference
We see three common kinds of contact or mechanical interference that can really hurt accuracy. First, if your stock has front and/or rear sling swivels make sure these do NOT contact the front or rear bags at any point of the gun’s travel. When a sling swivel digs into the front bag that can cause a shot to pop high or low. To avoid this, reposition the rifle so the swivels don’t contact the bags or simply remove the swivels before your match. Second, watch out for the rear of the stock grip area. Make sure this is not resting on the bag as you fire and that it can’t come back to contact the bag during recoil. That lip or edge at the bottom of the grip can cause problems when it contacts the rear bag. Third, watch out for the stud or arm on the front rest that limits forward stock travel. With some rests this is high enough that it can actually contact the barrel. We encountered one shooter recently who was complaining about “vertical flyers” during his match. It turns out his barrel was actually hitting the front stop! With most front rests you can either lower the stop or twist the arm to the left or right so it won’t contact the barrel.
3. Weigh Your Charges — Every One
This may sound obvious, but many folks still rely on a powder measure. Yes we know that most short-range BR shooters throw their charges without weighing, but if you’re going to pre-load for a club match there is no reason NOT to weigh your charges. You may be surprised at how inconsistent your powder measure actually is. One of our testers was recently throwing H4198 charges from a mechanical measure for his 30BR. Each charge was then weighed twice with a Denver Instrument lab scale. Our tester found that thrown charges varied by up to 0.7 grains! And that’s with a premium measure.
4. Measure Your Loaded Ammo — After Bullet Seating
Even if you’ve checked your brass and bullets prior to assembling your ammo, we recommend that you weigh your loaded rounds and measure them from base of case to bullet ogive using a comparator. If you find a round that is “way off” in weight or more than .005″ off your intended base to ogive length, set it aside and use that round for a fouler. (Note: if the weight is off by more than 6 or 7 grains you may want to disassemble the round and check your powder charge.) With premium, pre-sorted bullets, we’ve found that we can keep 95% of loaded rounds within a range of .002″, measuring from base (of case) to ogive. Now, with some lots of bullets, you just can’t keep things within .002″, but you should still measure each loaded match round to ensure you don’t have some cases that are way too short or way too long.
5. Check Your Fasteners
Before a match you need to double-check your scope rings or iron sight mounts to ensure everything is tight. Likewise, you should check the tension on the screws/bolts that hold the action in place. Even with a low-recoiling rimfire rifle, action screws or scope rings can come loose during normal shooting.
6. Make a Checklist and Pack the Night Before
Ever drive 50 miles to a match then discover you have the wrong ammo or that you forgot your bolt? Well, mistakes like that happen to the best of us. You can avoid these oversights (and reduce stress at matches) by making a checklist of all the stuff you need. Organize your firearms, range kit, ammo box, and shooting accessories the night before the match. And, like a good Boy Scout, “be prepared”. Bring a jacket and hat if it might be cold. If you have windflags, bring them (even if you’re not sure the rules allow them). Bring spare batteries, and it’s wise to bring a spare rifle and ammo for it. If you have just one gun, a simple mechanical breakdown (such as a broken firing pin) can ruin your whole weekend.
Share the post "Six Ways to Succeed at Local Fun Matches"
Koenig Triumphs for 19th Time
Team Ruger Captain Doug Koenig has just won the Bianchi Cup (NRA Action Pistol Championship) for the 19th time in his career. That is a remarkable accomplishment, as the the Bianchi Cup is considered by many to be the most unforgiving and difficult pistol competition on the planet. This legendary competition draws the top pistoleros from around the world. The Bianchi is Tough — for a chance to win overall, you basically have to “shoot clean”, with perfect stages.
Koenig won the Open Division and finished First Overall, capturing the title with a final 1920-182 Aggregate — truly impressive. Koenig took the win shooting a Ruger Custom Shop SR1911 Competition pistol. This championship was held at the Green Valley Rifle & Pistol Club in Hallsville, MO.
Koenig nailed perfect scores of 480 on all four Bianchi Cup events: Practical, Barricade, Moving Target and Falling Plates. That quadruple perfect performance earned Koenig an Aggregate score of 1920. In addition he completed the match with 182 total X-Ring hits, six more than the nearest competitor. By the way, Koenig (aka König) means “King” in the German language. There is no question that Koenig is King of the Bianchi Cup.
“Winning the Bianchi Cup title for the 19th time in my career is very special on its own,” said Koenig. “But to do so after the difficult year we’ve all faced, and to do so wearing a Team Ruger jersey, has made this win that much more meaningful for me.”
What skills does it take to win a Bianchi Cup? You need speed, accuracy, control, and discipline. Koenig explains some of these techniques in these two videos below. You’ll find 30 more Doug Koenig Videos on the NSSF YouTube Channel:
Share the post "The King Reigns — Doug Koenig Wins His 19th Bianchi Cup"
Top shooters like 11-time National Champion David Tubb have mastered marksmanship by being continually aware of their physical state while shooting. This article by Glen Zediker talks about respiration and how to modulate your breathing to maximize on-target accuracy and consistency. This article originally appeared in the MidSouth Shot Report Blog.
by Glen Zediker
Elsewhere I’ve talked about what I call the “true fundamentals” of shooting. Put the sight on the target and pull the trigger without moving the sight. And we’ve talked about some of the mechanics, like natural point of aim, sight picture, and the trigger itself, that combine to assist this goal.
Holding still sometimes takes more thought, and effort, than we might realize. Shooting well is a truly multi-faceted task that shooters like 11-time National Champion David Tubb have attended to through miniscule details, like being aware of the physical state continually while performing.
Another crucial and largely unknown element is controlling breathing. Right. That thing we do to stay awake and alive. Breathing can be a calculated technique among competitive shooters, and that is because the state of the body in the framework of making a shot is a defining element in the effectiveness of the shooting platform. That platform, by they way, is you!
I’ll break it down, and then offer a few suggestions on how to incorporate a better understanding of the dynamics of maintaining human oxygen supply.
When we are breathing when doing nothing in particular but living, we’re not taking the deepest breaths we can when we inhale, and we’re not expelling all the air we had when we exhale. We’re also not breathing in and out, in and out, in and out in constant successions. We breathe in to a comfortable level. Hold that a bit. We breathe out to a comfortable level. And then we hold that state for a bit. Then we very naturally breathe in again. These cycles are on a balanced rhythm, and a relatively shallow cycle. It’s a lot different than when we’re doing something strenuous, like running.
So, to fire a gun from our most stable state, make the trigger break in what shooting coaches call “the natural respiratory pause”. That’s the state between exhaling and inhaling. From a “human machine” standpoint, that’s when the body is most calm and stable.
Breathing Cycles for Best Shooting
Learn to use the natural pattern of your breathing to experience the most effective (steadiest) hold. When we breathe normally we don’t inhale as much air as we can hold and then blow it all out, and we also don’t breathe continually in and out, in and out. Rather, we simply inhale and exhale to levels that are comfortable to us. Take aim and fire the shot when you have reached what some call the “natural respiratory pause,” or the natural resting point prior to inhalation where we are “using” the oxygen we have retained.
It’s a narrow window. That window of opportunity varies widely depending on a lot of factors, but some experience dry-firing will show you where you stand.
1. Align Front Rest and Rear Bag
5. Check Your Fasteners
Koenig Triumphs for 19th Time
