Horus Video Explains Sources of Zero Shift in Rifle Scopes
In the above video, a spokesman for Horus Vision explains how and why scopes can experience zero shift. First, just cleaning the gun can cause a small shift in point of impact. Second, when you re-tighten rings and ring bases, this can cause a change in zero. Horus recommends that you use a torque wrench to confirm that you maintain the same torque settings each time. The same goes for action screw tension — tensioning your action screws can shift the point of impact.
Other factors that can cause a change in zero:
Temperature
Dramatic ranges of temperature will change your zero, because the air density affects the velocity of the bullet. With increased temperature, there may be a higher velocity (depending on your powder).
Gun Handling and Body Position
You rifle’s point of impact will be affected by the way you hold the gun. A “hard hold” with firm grip and heavy cheek weld can give you a different POI than if you lightly address the gun. Even when shooting a benchrest gun, the amount of shoulder you put into the rifle can affect where it prints on paper.
Type of Rifle Support — Bench vs. Field
Whenever you change the type of rifle support you use, the point of impact can shift slightly. Moving from a bipod to a pedestal rest can cause a change. Similar, if you switch from a mechanical rest to sandbags, the gun can perform differently. That’s why, before a hunt, you should zero the gun with a set-up similar to what you would actually use in the field — such as a rucksack or shooting sticks.
Transportation of Firearms
Even if you don’t mishandle your weapon, it is possible that a shift of zero could occur during transport. We’ve seen zero settings change when a tight plastic gun case put a side load on the turrets. And in the field, if the turret knobs are not covered, they can rub against clothing, gear, storage bags, scabbard, etc. If the knobs turn, it will definitely move your reticle slightly and cause your point of impact to be off.
Similar Posts:
- Custom-Calibrated Windage & Elevation Knobs from Kenton
- Kenton Offers Custom-Calibrated Windage and Elevation Knobs
- Kestrel Weather Meter with Built-in Horus Ballistics Software
- Powder Temp Stability: IMR Enduron vs. Hodgdon Extreme
- Tuned Windage Compensating Knob from Kenton
Share the post "Horus Video Explains Sources of Zero Shift in Rifle Scopes"
THIS SHORT WRITE UP IS WHAT I HAVE BEEN TEACHING FOR YEARS. I AM A GUNSMITH AND WAS ALSO CAPTAIN OF THE SNIPER PORTION OF A SWAT TEAM FOR A SHERIFFS DEPT. FIRED THOUSANDS OF ROUNDS AND CONFIRMED WHAT WE BOTH KNOW. WE BUILD 10 TO 20 THOUSAND DOLLAR RIFLES AND THE INFO IN THIS ARTICLE SAYS IT ALL. GOOD ADVICE. HORUS VISION. TOP NOTCH!
I CAN’T FIND MY CAPS LOCK KEY TO TURN THEM OFF.