Federal Offers Syntech Polymer-Coated Bullets for Hand-Loaders
Here’s something that may benefit pistol shooters, especially those who shoot steel and often shoot at indoor ranges. Federal Syntech bullets are now available as reloading components in 9mm, .40 Cal (10mm), and .45 Caliber. These bullets feature a total synthetic jacket (TSJ) polymer coating. The potential for reduced wear and fouling is real — when tested against conventional FMJ ammunition, Federal claims Syntech produced an average of 12% less barrel friction and 14% less heat. By eliminating the conventional bullet jacket, the Syntech design greatly lessens bullet “splashback” when shooting steel. Note, however, Syntech bullets still have a conventional lead core. This means they may not be allowed in ranges with lead restrictions.
Syntech Bullets Tech Information | Syntech Bullets LOAD DATA for 9mm, .40 SW, .45 ACP
Syntech Bullet Features & Benefits
• Polymer-encapsulated Syntech bullet prevents metal-on-metal contact in the bore.
• Eliminates copper and lead fouling.
• Decreases heat and friction, extending barrel life.
• Significantly reduces the required frequency of cleaning.
• Absence of a copper jacket minimizes splash-back on steel targets.
Part No. / Description / MSRP
AE9SJCB1 / 9mm, .355″ 115-grain Syntech, 100-count / $16.95
AE40SJCB1 / .40 cal., .400″ 165-grain Syntech, 100-count / $18.95
AE45SJCB1 / .45 cal., .451″ 230gr Syntech, 100-count / $21.95
For years this Editor has loaded his .45 ACP and .44 Mag handguns with polymer/moly matrix-coated bullets from Precision Bullets in Texas. Those poly/moly-encased lead bullets shot VERY accurately and I found that my barrels fouled much less than with conventional lead bullets. Likewise, there was much less cylinder fouling on my revolvers. If the American Syntech bullets work as well as those Precision bullets, I think the Syntech line will be a winner. Syntech bullets should benefit any high-volume pistol shooter, particularly competitors who shoot steel.
Similar Posts:
- New Federal Syntech Ammo with Polymer-Encased Bullets
- Federal Syntech Pistol Ammunition with Polymer-Coated Bullets
- Federal Syntech Polymer-Coated Handgun Ammo Runs Cleaner
- CCI’s New .22 WMR Clean-22 Ammo with Polymer-Coated Bullets
- CCI Clean-22 Rimfire Ammo with Polymer-Coated Bullets
Share the post "Federal Offers Syntech Polymer-Coated Bullets for Hand-Loaders"
Tags: Federal, handgun bullets, IDPA, IPSC, pistol bullets, Polymer jacket, Polymer-coated bullets, Syntec, Syntech
Now if they would just offer the 230 grain .451 GMM bullet.
I bought some of these in 45 ACP. Only problem is that I cant find any load data for them. Since they have less friction, I would think you would use less powder. Do you know of any load data out there for these?
Thanks
Ron
I have purchased and reloaded Syntech bullets but the dealer quit carrying reload supplies. Who carries them in the Boise Idaho / Nampa / Caldwell areas??
Virginian’s can only use LEAD Ammo if Democrat-bills past…..