February 22nd, 2020

.224 Valkyrie Barrel Cut-Down Velocity Test — 4 Ammo Types

224 .224 Valkyrie barrel cut-down test velocity 90gr Sierra MatchKing Fusion SP TMK

224 .224 Valkyrie barrel cut-down test velocity 90gr Sierra MatchKing Fusion SP TMKVelocity vs. barrel length — How much speed will I sacrifice with a shorter barrel? Hunters and competition shooters often ask that. Today we DO have solid answers to that question for many cartridge types thanks to Rifleshooter.com.

Rifleshooter.com has conducted a series of barrel cut-down tests for many popular chamberings: .223 Rem, 6mm Creedmoor, .243 Win, 6.5 Creedmoor, .308 Win, .300 Win Mag, .338 Lapua Magnum and more. And recently Rifleshooter.com added the new .224 Valkyrie cartridge to the list, cutting a 28″ Shilen barrel down to 16.5″ in one-inch increments. Rifleshooter.com measured the .224 Valkyrie’s velocities at each barrel length with four different types of factory ammo.

For its .224 Valkyrie test, RifleShooter.com sourced a Shilen Match Barrel and fitted it to a Rem 700 short action employing a one-piece PT&G bolt with the required .440″ (SPC-sized) bolt-face. The barreled action rides in a MDT LSS-XL Gen 2 Chassis.

READ .224 Valkyrie Barrel Cut-Down Test on Rifleshooter.com »

Bill, Rifleshooter.com’s Editor, explained his test procedure:

“I gathered four different types of factory Federal 224 Valkyrie ammunition, the 90gr Sierra MatchKing (SMK), 90gr Fusion soft point (SP) (referred to a Fusion MSR), 75gr Total Metal Jacket (TMJ) and 60gr Nosler Ballistic Tip Varmint (NBT). After a brief barrel break in and zero, I fired 5 rounds of each cartridge at each barrel length (except the 75 TMJ, I fired 4 rounds at each barrel length due to limited resources). I recorded the average muzzle velocity and standard deviation for each ammunition and barrel length combination and cut the barrel back 1 inch and repeated the process. I recorded barrel lengths from 28″ to 16.5″ (I try to save these barrels as finished 16″ tubes so they don’t go to waste).”

224 .224 Valkyrie barrel cut-down test velocity 90gr Sierra MatchKing Fusion SP TMK

The Heavy Bullet 90gr Ammo Lost about 21 FPS per Inch
How did the test turn out? You’ll find all the results summarized in helpful tables with inch-by-inch velocity and SD numbers. For the two, 90gr ammo samples, results were similar. The 90gr SMK ammo started at 2782 fps (28″), finishing at 2541 fps (16.5″). That’s a loss of 241 fps, or 20.96 fps average per inch of length. The ammo loaded with 90gr Fusion SPs started at 2797 fps (28″) and ended at 2561 fps (16.5″), a drop of 236 fps. That’s 20.5 fps loss per inch. NOTE: Ambient temperature during the test was 45° F. You could expect the overall velocities to be a bit higher during hotter summer months.

See 90gr SMK Velocity/Length Test Chart | See 90gr Fusion SP Velocity/Length Test Chart

.224 Valkyrie Velocity Cut-Down Test

With a the smaller bullets, the effect was even more dramatic. As you’d expect they started out faster. The ammo with 60gr Nosler Ballistic Tips (NBT), a good choice for varminters, started at 3395 fps (28″), and declined to 3065 fps (16.5), a total velocity drop of 330 fps. Average velocity loss was 28.7 fps per inch of barrel length. Rifleshooter.com also tested Federal 75gr TMJ ammo.

About the .224 Valkyrie Cartridge

224 .224 Valkyrie barrel cut-down test velocity 90gr Sierra MatchKing Fusion SP TMK

The new .224 Valkyrie was introduced late last year as a Hot Rod cartridge that will work in AR15s. Designed to rival the .22 Nosler while still running well in ARs, the new .224 Valkyrie offers excellent long-range performance when loaded with modern, high-BC bullets. We expect some bolt-action PRS shooters might adopt the .224 Valkyrie. Why? Reduced recoil. With the 90gr SMK, the .224 Valkyrie offers ballistics similar to the 6.5 Creedmoor but with significantly less felt recoil. Check out this chart from Federal showing comparative recoil levels:

.224 Valkyrie Federal Rifleshooter.com cut-down barrel

.224 Valkyrie vs. .22-250 Remington
The Social Regressive explains: “There are two key reasons why the 224 Valkyrie is unique and desirable. First, it is specifically designed to fit the limitations of the AR-15 platform. It does so even when loaded with gigantic bullets, like the 90-grain SMK that Federal announced. .22-250 Rem is too long and too fat to work in the AR-15 platform; it needs an AR-10 bolt and magazine.”

Image from Social Regressive .224 Valkyrie Youtube Video.

The new .224 Valkyrie is basically a 6.8 SPC case necked down to .22-caliber. You can use your existing AR15 lower, but you will need a dedicated .224-Valkyrie upper, or at the minimum a new barrel, modified bolt with proper bolt face, and 6.8-compliant mags.

Permalink - Articles, Bullets, Brass, Ammo, Gear Review, Gunsmithing, Tech Tip 1 Comment »
February 22nd, 2020

Doh! Make Sure Your Ammo Fits Your Chamber!

Ruptured Cartridge Case

If you don’t match your ammo to your chamber, bad things can happen, that’s for sure. A while back, Forum member BigBlack had an experience at the gun range that reminds us of the importance of safety when shooting. He encountered evidence that someone had fired the wrong cartridge in a 7mm WSM rifle. The problem is more common than you may think. This Editor has personally seen novices try to shoot 9mm ammo in 40sw pistols. BigBlack’s story is along those lines, though the results were much more dramatic. It’s too bad a knowledgeable shooter was not nearby to “intervene” before this fellow chambered the wrong ammo.

7mm-08 is Not the Same as a 7mm WSM
BigBlack writes: “I know this has probably been replayed a thousand times but I feel we can never be reminded enough about safety. This weekend at the range I found a ruptured case on the ground. My immediate thoughts were that it was a hot load, but the neck area was begging for me to take a closer look, so I did. I took home the exploded case and rummaged through my old cases until I found a close match. From my investigative work it appears someone shot a 7mm-08 in a 7mm WSM. Take a look. In the above photo I’ve put together a 7mm WSM case (top), the ruptured case (middle), and a 7mm-08 case (bottom).”

The photo reveals what probably happened to the 7mm-08 case. The shoulder moved forward to match the 7mm WSM profile. The sidewalls of the case expanded outward in the much larger 7mm WSM chamber until they lacked the strength to contain the charge, and then the case sides ruptured catastrophically. A blow-out of this kind can be very dangerous, as the expanding gasses may not be completely contained within the action.

Can’t Happen to You? Think Again.
This kind of mistake — chambering the wrong cartridge — can happen to any shooter who is distracted, who places even a single wrong round in an ammo box, or who has two types of ammo on the bench. One of our Forum members was testing two different rifles recently and he picked up the wrong cartridge from the bench. As a result, he fired a .30-06 round in a .300 Win Mag chamber, and the case blew out. Here is his story:

“I took two of my hunting rifles I have not used for over 25 years to the range yesterday to get new scopes on paper, a .30-06 and .300 Win Mag. I had four boxes of old Winchester factory ammo (two of each cartridge), which had near identical appearances. I accidentally chambered a .30-06 round in the Sako .300 Win Mag rifle. It sprayed powder on my face and cracked the stock at the pistol grip. If I had not been wearing safety glasses I might be blind right now.

Safety eyewear glasses
You should always wear protective eyewear, EVERY time you shoot.

“I feel lucky and am very thankful for being OK — other than my face looks funny right now. I am also grateful for learning a valuable lesson. I will never put two different cartridges on the bench at the same time again.”

READ More about this incident in our Shooters’ Forum.

Permalink Reloading, Tech Tip 5 Comments »
February 22nd, 2020

Show Off your “Wallet Groups” with Shoot’n Aces Cards

Bell & Carlson stocks shooting card Shoot'n Aces playing target cards

Want to show off some groups you’ve shot? Or keep a handy pack of mini-targets in your range kit? Then check out this unique product from stockmaker Bell & Carlson. Shoot’n Aces cards feature a 1-inch black square aiming box with a 1/2-inch inner square. These cards are normal poker-playing-card size, 3.5″ high x 2.5″ wide (89 × 64 mm). Shoot’n Aces cards come 56 to a pack. Carry a few extras in your wallet or a pack in your vehicle glove compartment and you’ll always have a precision target to shoot at the range. Cards can be stapled or taped to target stands.

Bell & Carlson stocks shooting card Shoot'n Aces playing target cards

Bell & Carlson stocks shooting card Shoot'n Aces playing target cardsSniper Central says these cards work well as targets: “The bold square is easy to pick up with the inner white portion making a nice aiming point. The material of the cards is the same as normal playing cards and the bullets make a very nice hole when passing through.” The sharp edges of the bullet holes makes it easy to measure group sizes with precision.

Each pack of Shoot’n Aces contains 56 premium-quality target cards. If you want some, order Bell & Carlson item SA-2006. This is a set of four (4) card-packs with 56 cards per pack (224 cards total) priced at $20.00 (i.e. $5.00 per pack).

Product Tip from EdLongrange. We welcome reader submissions.
Permalink New Product, Shooting Skills No Comments »