TECH Tip — When and How to Clean Your Reloading Dies
After purchasing a new set of dies from Forster, Hornady, Redding, or Whidden Gunworks, you’ll want to disassemble the dies, inspect then, and then remove the internal grease and/or waxy coatings placed on the dies by the manufacturer. Here are two video that show how to de-grease and clean dies as they come “out of the box” from the manufacturer. In the first video, from Creedmoor Sports, Bill Gravatt (now President of Capstone Precision Group) shows various methods for cleaning dies both when new and after they have accumulated carbon and lube after use. This video is definitely worth watching. In the second video, a Hornady technician shows the method for degreasing dies before first use. A convenient aerosol spray cleaner is used in the video. You an also use a liquid solvent with soft nylon brush, and cotton patches. NOTE: After cleaning you may want to apply a light grease to the external threads of your dies.
Creedmoor Sports Die Cleaning Video with Bill Gravatt
Hornady Video Showing Aerosol Cleaner
Clean Your Sizing Dies and Body Dies Regularly
These same techniques work for cleaning dies after they have been used for reloading. Many otherwise smart hand-loaders forget to clean the inside of their dies, allowing old case lube, gunk, carbon residue, and other contaminants to build up inside the die. You should clean your dies fairly often, particularly if you do not tumble or ultrasound your cases between loadings. It is most important to keep full-length sizing and body dies clean. These dies accumulate lube and carbon residue quickly.
Similar Posts:
- How to Properly Clean Your Reloading Dies
- Reloading Die Maintenance — When and How to Clean Your Dies
- How to Properly Clean Reloading Dies — Die Maintenance Tips
- Cleaning Tips for Cartridge Brass and Reloading Dies
- Cleaning Cartridge Brass & Reloading Dies — Methods Explained
Share the post "TECH Tip — When and How to Clean Your Reloading Dies"
Tags: Bill Gravatt, Die Maintenance, RCBS Dies, Redding Dies, Reloading Die, Whidden Dies
why cleaning outside?
and for inside cleaning with q-tip only is not enough?
I have read a lot about brass that you might reload, as the measuring of the brass goes. For inside volume, some say just weight the brass, others say, fill it up with water then weight. or better said weight the brass frist then fill it up with water then weight and subtract the difference. a lot of time spent, would it be worth it? Yes I do clean my dies very regular.