October 10th, 2013

Wind Box Shelters Scales When Reloading at Outdoor Ranges

Shooters who reload at the range, during the course of benchrest matches, or during load development sessions, can benefit from having a portable scale to weigh charges. Even if you throw charges, using click values, a scale allows you to double-check the accuracy of your throws. In addition, having a scale handy lets you weigh and sort components during load development.

Many reloaders prefer “old-fashioned” balance beam scales for range use. They are relatively inexpensive and simple to use. With a beam scale, unlike electronic scales, you don’t have to worry about weak batteries or finding AC power. The problem when using any scale at an outdoor range is wind. Wind can cause powder to blow out of the pan and even a light breeze can actually cause a beam scale to perform erratically.

Beat the Breezes with a Wind Box for your Scale
Forum member Boyd Allen has come up with a smart solution for reloaders who use scales outdoors — a windproof scale enclosure, aka “Wind Box”. This is something that can easily be built at home with common tools. Boyd explains: “Many guys have good set-ups for loading at the range, with clamping mounts for powder measure and press. But they lack a good enclosure for a scale. This is vitally important with beam scales because they have a lot of surface area to catch the wind. With much wind at all, the beam can oscillate to the point that is not really very usable. While a low-profile electronic scale may be less wind-sensitive, breezes DO affect weight read-outs on digital scales. And of course you always have the issue of blowing powder particles.”

Wind box range reloading

Boyd Allen has used his Wind Box successfully for many seasons. He explains: “Some time ago, I got this idea, and was fortunate enough to have a friend, Ed Hellam, who liked the idea well enough to build us both one. He did a fine job, but since this was the prototype there was at least one lesson to learn. The original viewing pane was Plexiglass, and I discovered that it would hold enough static charge to throw the scale off 0.1 grains, so another friend, Bob Smith, modified my Wind Box, replacing the Plexiglass with a tempered glass faceplate. Thank you Ed and Bob….

The essence of the idea is to have a scale set up in a box with a clear cover that can be opened and closed. On one side the trickler handle/control emerges through a ‘just big enough’ hole. You raise the cover, add a sub-target-weight thrown charge to the pan, and then close the cover. With the cover secure, the set-up is protected from the wind, and you can now trickle up to your desired charge. It works very well. The scale in the photo is an old Ohaus that I picked up. It is actually more sensitive than my RCBS 10-10 and works fine. You can adapt this Wind Box design to any beam scale, or portable electronic scale. Simply adjust the dimensions to fit your particular scale and trickler.”

Wind box range reloading

Similar Posts:

Tags: , , , , ,