Use Stub Gauge to Check Shoulder ‘Bump’ and Seating Depth
Forum member Rich DeSimone uses a handy “Stub Gauge” for setting shoulder “bump” and seating depth. The gauge is made from a section of barrel lopped off when the muzzle is crowned. The chambering reamer is run in about 1/4 of the way, enough to capture the neck and shoulder area of the case. Rich then uses his full-length die to “bump” a master case with the ideal amount of headspace for easy feeding and extraction. He takes that case and sets it in this Stub Gauge, and measures from the front of the gauge to the rim. He can then quickly compare any fired case to a his “master” case with optimal headspace. Since the gauge measures off the shoulder datum, this tells him how much to bump his fired brass.
In addition, the Stub Gauge can be used to set bullet seating-depth. Rich has a channel cut transversely on one side of the gauge, exposing the throat area. Since the interior of the gauge is identical to the chamber in his gun, this lets him see where a seated bullet engages the rifling. He can tinker with bullet seating length until he gets just the right amount of land contact on the bullet, confirmed visually. Then he measures the case OAL and sets his seating dies accordingly. This is much handier than using a Stoney Point Tool to measure distance to the lands. As your barrel’s throat wears, you may seat your bullets out further to “chase the lands”, but the gauge provides a constant land engagement point, in the barrel’s “as new” condition. By measuring the difference between the land contact point on the gauge and the actual contact point on your barrel, you can determine throat “migration”.
Similar Posts:
- Use Stub Gauge to Check Shoulder Bump, Monitor Throat Erosion
- TECH TIP–Stub Gauge for Measurements
- The Stub Gauge — Why You Should Have this Handy Tool
- Got Stub? Barrel Stub Gauges Serve Many Functions
- Barrel Stub Gauges — Handy for Many Reloading Tasks
Share the post "Use Stub Gauge to Check Shoulder ‘Bump’ and Seating Depth"
Tags: Barrel, Chambering, Chase Lands, Leade, Reloading, Stub Gauge, Tech Tip, Throat
I use a stub gauge for all my chamberings, but I don’t have a “window” cut into any of them. with the bullet inserted in the stub and resting on the lands, I can determine the dimensions(s) relative to the bullet/stub and case/stub to determine the distance to the lands on a new chamber. As stsated, invaluable for die setup/ shoulder bump.