Powder Moisture Content — What You Need To Know
This Technical Report Comes from the Vihtavuori website.
Powder Moisture Content — Did You Know?
Variations in moisture content change the burning rate of a powder and thereby chamber pressures and muzzle velocity. The moisture content of the Vihtavuori N100 and N300 series powders is usually around 1%, while the N500-series’ normal moisture content is 0.6% because of the added nitroglycerine.
So what difference does moisture content make? Here’s an example. In a test, a [Vihtavuori] powder sample was dried by heating it, losing about 0.5 % of its weight. Cartridges were then loaded with the dried powder and fired using a pressure gun. Chamber pressures and muzzle velocities produced by these special cartridges were compared to those produced by cartridges loaded with untreated powder. (The powder charge and bullet were of course the same in both sets of cartridges.)
After Powder Drying:
Pressure Increased 11% from 320 MPa to 355 MPa
Velocity Increased 2.6% from 2526 to 2592 FPS
Comparing results showed chamber pressures increased from 320 MPa to 355 MPa with the dried powder, and the muzzle velocity increased accordingly from 770 m/s to 790 m/s (2526 to 2592 FPS). And note, this is only one example, of one caliber and loading. The difference might be much higher depending on the cartridge and loading combinations.
Recommendation: Store powder below 68°F in 55-65% humidity.
What does this tell us? Well, it seems we need to forget the old saying “Keep your powder dry”! Instead, focus on proper powder storage, at a temperature below 20°C/68°F and humidity between 55 and 65%. Safe reloading everybody!
Similar Posts:
- How Powder Moisture Content Affects Pressure and Speed
- Humidity Changes Can Alter Powder Burn Rates and Performance
- TECH TIP: Humidity Can Change Powder Burn Rates
- Humidity and Powder Burn Rates — What You Need to Know
- Changes in Humidity Can Alter Powder Burn Rates — IMPORTANT
Tags: Humidity, Powder, Powder moisture content, Vihtavuori
The change in pressure could be even more significant. Dry powder rises pressure it also weighs less. So if the reloader is weighing his powder he will be using more of it increasing the pressure even more.