Watch Out for Bullet Nose Contact in Short Seating Stems
Clearance Check — Remove the seating stem and drop a bullet into it. The farther down the ogive or nose-cone the step recess grips the bullet, the better. If it’s only pressing down against the bullet tip, a crooked seat is assured, along with inconsistent seating depth. — Glen Zediker
Some folks acquire a new seating die and then are surprised to find their hand-loads show crooked bullets and/or inconsistent seating depth. The problem could be a mis-match between the bullet and the die’s seating stem. In some case, particularly with long, streamlined bullets, the bullet tip can actually touch the bottom inside of the stem. This can cause a variety of problems, as Glen Zediker explains…
Invest in a Good Seating Die
Reloading Tip by Glen Zediker
The bullet seating operation is the “last thing” that happens and it’s also the one thing that can corrupt the care and treatment given to the quality of the loaded round prior. A sleeve-style seater, well-machined, goes a whopping long ways toward preserving alignment, and, therefore, concentricity. Also make sure that the stem in yours comes to rest well down onto the bullet ogive, and, above all else, is not contacting the bullet tip! That will wreck a round.
If you have this problem, you should contact the die maker — some will offer a different seating stem expressly designed for longer, pointier bullets. This “long bullet stem” will normally drop right into your existing die. If you plan to run long, VLD-style bullets you should request the special seating stem right from the get-go.
This tip comes from Glen’s newest book, Top-Grade Ammo, available at Midsouth Shooters Supply.
Similar Posts:
- Check for Bullet Tip Contact with Seating Die Stems
- Polish Inside of Seating Stems to Avoid Ring Marks on Bullets
- TIP: Polish Seating Stems to Eliminate Ring Marks on Bullets
- Bullet Seating Advice — How to Avoid Ring Marks on Your Bullets
- For Better Bullet Seating — Try Lapping Inside of Seating Stems
Share the post "Watch Out for Bullet Nose Contact in Short Seating Stems"
Tags: Forster Die, Glen Zediker, Reloading, Seating Die, Seating Stem
Before inserting the bullet, I put a drop of Prussian blue on the meplat. This makes it easy to observe whether the tip is against the stem bottom.