Reloading at the Range — Smart Option for Load Development
The February 2013 edition of Shooting Sports USA magazine has an interesting feature by Glen Zediker. In this Transporting Success, Part I article, Zediker explains the advantages of loading at the range when your are developing new loads or tuning existing loads. Glen, the author of the popular Handloading for Competition book, discusses the gear you’ll need to bring and he explains his load development procedure. In discussing reloading at the range, Glen focuses on throwing powder and seating bullets, because he normally brings enough sized-and-primed brass to the range with him, so he doesn’t need to de-prime, re-size, and then re-prime his cases.
Zediker writes: “Testing at the range provides the opportunity to be thorough and flexible. You also have the opportunity to do more testing under more similar conditions and, therefore, get results that are more telling. Once you are there, you can stay there until you get the results you want. No more waiting until next time.”
Zediker starts with three-shot groups: “I usually load and fire three samples [with] a new combination. I’ll then increase propellant charge… based on the results of those three rounds, and try three more. I know that three rounds is hardly a test, but if it looks bad on that few, it’s not going to get any better.”
Glen reminds readers to record their data: “Probably the most important piece of equipment is your notebook! No kidding. Write it down. Write it all down.”
There’s More to the Story…
Editor’s Note: In Zediker’s discussion of loading at the range, he only talks about throwing powder and seating bullets. In fact, Glen opines that: “there is little or no need for sizing.” Well, maybe. Presumably, for each subsequent load series, Zediker uses fresh brass that he has previously sized and primed. Thus he doesn’t need to de-prime or resize anything.
That’s one way to develop loads, but it may be more efficient to de-prime, re-size, and load the same cases. That way you don’t need to bring 50, 80, or even 100 primed-and-sized cases to the range. If you plan to reload your fired cases, you’ll need a system for de-priming (and re-priming) the brass, and either neck-sizing or full-length sizing (as you prefer). An arbor press can handle neck-sizing. But if you plan to do full-length sizing, you’ll need to bring a press that can handle case-sizing chores. Such a press need not be large or heavy. Many benchresters use the small but sturdy RCBS Partner Press, on sale now at Amazon for $77.99. You may even get by with the more basic Lee Precision Compact Reloading Press, shown in Zediker’s article. This little Lee press, Lee product #90045, retails for under $35.00.
Similar Posts:
- Zediker Article Discusses Merits of Reloading at the Range
- Reloading at the Range — Zediker Explains the Basics
- Good Resource for Handloaders Who Want to Make Better Ammo
- Zediker Reloading Book — Worth Checking Out
- Book Review: Handloading for Competition by Glen Zediker
Share the post "Reloading at the Range — Smart Option for Load Development"
Tags: Arbor Press, Glen Zediker, Lee compact press, Range, RCBS Partner Press, Reloading, Zediker
I have been reloading at the range for decades. Reluctance to do this and use one’s own wind flags are IMO the two biggest things that keep shooters from achieving their equipment’s maximum accuracy. Being able to make quick load changes right where you are shooting is an immense advantage.
As Boyd mentioned the ONLY way to get the most of of your rifle is loading at the range. Granted it does take xtra $$ for addl equipment.
For those “Loaded at Home” loads that have issues at the range can be verified or dismissed by loading at the range saves for a lot of “What If’s” travel time and aggravation.
Jim