More RCBS ChargeMaster Optimization Tips
If you own an RCBS ChargeMaster 1500 electronic powder scale/dispenser, or are thinking about purchasing one, here are a few tips that can cut your loading times and eliminate some petty annoyances.
Mute That Annoying Beep
Some ChargeMaster users complain about the loud beep at the end of each cycle. There’s a simple way to silence the beep — and you don’t have to cut any wires or permanently disable the speaker. To mute the beep, simply hold down the Zero button until “beep off” displays. Repeat this procedure to restore the beep function.
Activating the Auto-Dispense Mode
You can set the ChargeMaster to automatically dispense your pre-programmed charge as soon as you put the pan back on the scale. Simply press and hold the “Enter” button. The code “Auto” should then appear on the display. At this point, push “Disp” to dispense the first charge. When you replace the pan, the unit will automatically dispense the same charge. For some people this is an added convenience. You can always go back to the default manual dispense method by changing the dispense mode using the “Enter” button again.
Use a McDonald’s Straw to Reduce Over-Throws
Jaco Brink provided another useful tip to avoid “over-throws” (excess charge weight): “The RCBS employee advised me to take a McDonnell’s straw (because it is thicker than a normal straw), cut off about a half inch piece and put it into the tube where the powder exits. This caused the last part of an extruded powder to cluster less, and reduced the amount of overthrows dramatically.”
Instructional Video
The video below shows how to set up and calibrate a Chargemaster 1500. Be sure to level the unit carefully, both left to right and front to back. Starting at the 1:44 mark in the video you can see the unit dispense a 50-grain charge in 30 seconds. The slow, final trickle stage takes about half of the total time.
How to Shorten Dispensing Times
The last tip is for advanced users only. You can alter the programming settings to speed up powder dispensing dramatically. One user reported that, by re-programming his machine, his cut his dispensing time for a 30-grain load from 22 to 13 seconds “with no overthrows”. WARNING: once you change the parameters, there is no “restore” command to set everything back to the defaults. So proceed carefully. The speed enhancement procedure is described on the pages linked below:
Basic ChargeMaster Speed Enhancement | Advanced ChargeMaster Programming Tips
This post has also been Jacked. Your content has been hijacked at this Plagiarism Site
Editor: The poster is correct. MyHuntingSite.com has taken this post, word for word, and re-posted it without attribution. That’s a copyright violation.
Fine tuning the throw speed parameters is the way to go. I went from maybe 2 6.5 load throws a minute to close to 4. They have some good reads about the changes you make and how you want to adjust numbers versus what they relate to. It is mostly all the time spent slowing down in steps that takes so long. If you can get those times down and use the straw trick you can get fast accurate throws. You can always re-enter the factory default values later if you want so don’t sweat no manual default reset option. You will only be messing with 3 parameters anyway they rest will all be left stock.