Berger’s New 6mm 105gr Hybrid Match Bullets — First Look
by Robert Whitley
I recently received some of the new Berger 6mm 105gr Hybrid Match Bullets for testing. There is much interest in these new 6mm Hybrids, so I thought I’d share my initial observations. A couple of things are very striking about these new bullets:
1. They appear to be very long, sleek and aerodynamic, while they still maintain a good bearing surface length (full-diameter shank). I like bullets with a sufficient bearing surface length because I find that it makes for bullets that are easier to shoot and tune. I also feel a good bearing surface length makes for a bullet that has a better potential for consistent performance over bullets with a short bearing surface.
2. The published ballistic coefficient (BC) numbers on these bullets are quite high. They have a stated G1 BC of .547 and a G7 BC of .278. Looking at the bullets themselves it’s easy to see why these BC numbers are so high. The front end of the projectile is quite long and similar to what you see on long-range VLDs, but the transition to the bearing surface has a blended appearance (the Hybrid part) vs. the sharp transition you typically see with most VLDs and secant ogive bullets. The 105gr Hybrid bullets also have a long boat-tail.
3. The new Berger 105gr Hybrid bullets measure right around 1.261″ OAL. By comparison, the many other 105gr to 108gr bullets I’ve measured all seem to run in the range of 1.210″ to 1.225″ OAL. The Berger 105gr Hybrid bullets are thus a fair bit longer than the others, which is why a true 1:8″ or faster twist is recommended for them. The bearing surface diameter of the new Hybrids was dead on at 0.243″. So these bullets are neither “fat” nor “skinny”.
4. The tips on these bullets are quite uniform, with the meplats closed up nicely. The Hybrids have nice small tips similar those on the Berger 108s (reasonably tight in diameter). While I sometimes like to point my match bullets, I like to shoot bullets that are ready to go “out of the box”, and these are just that. I’m hoping they will perform very well without meplat trimming or pointing.
Berger’s 6mm 105gr Hybrids Slated to Go on Sale in Late October
Berger has done its own in-house testing on these bullets and found them to be accurate and appropriate for release for additional testing by shooters out in the field. Unless this additional field testing reveals something that no one anticipated (which I doubt), I suspect these new projectiles will be one of Berger’s most popular bullet offerings. The planned official release date for the new 6mm, 105gr Hybrids has been tentatively set for mid- to late-October of 2011. So, barring some last minute changes, these 105s should be on dealers’ shelves before Thanksgiving.
Similar Posts:
- New Berger .30-Cal Hybrids Released — 6mm Hybrid in Testing
- New Berger 105gr 6mm Hybrid Bullets Perform Well
- Berger Hybrid Bullets — What You Need to Know
- Hybrid Science: How to Load Hybrid Bullets for Best Accuracy
- New Berger 200.20X 30-Cal Bullet with 0.640 G1 BC Available
Share the post "Berger’s New 6mm 105gr Hybrid Match Bullets — First Look"
Yeah it’s hard to believe Berger could improve on their 105VLD product, as good as they shoot in my rifles! I’m really anxious to try a few of the sample Hybrids I received earlier this week; will be doing some testing @ 600 yards (maybe 1,000 or 1,200 too) next week.
Only problem I see with these is I can’t buy them yet
Going to test mine over a chrono at 100 & 200 yards, then head to head vs the VLDs at 600.
They sure “look” nice…we’ll see how they fly Saturday….
Tried some today on our Ground Hog Targets at 200/300/500 meters.
Shot them head to head against my proven 105 VLD load. Exact same load just a little different seating depth.
At 500 meters the new Hybrids printed 1.11 inches higher than the VLD and the initial grouping was tighter. I’m going to use them in our match this Saturday and will report back.