November 26th, 2007

TECH TIP: Citranox Solution for Ultrasonic Case Cleaning

Citranox Case CleanerForum Member Dave B., aka “Gunamonth”, is a chemist/physicist with decades of experience working with the ultrasound process. He has achieved great results cleaning cases via ultrasound. Dave tried a variety of solutions and he favors a mix of water and Citranox®. This achieved the best results, and did not require a separate neutralizing step if you rinse the cases thoroughly after. Citranox, mixed 1:75 or 1:100 with water (distilled H20 is best), is inexpensive to use. Phospate-free Citranox® contains a blend of organic acids, anionic and non-ionic surfactants and alkanolamines. For more information on using Citranox®, check out THIS FORUM THREAD.

Dave notes: “I had a lot of communication with the technical VP of Alconox about trying to clean fired cases with an ultrasonic unit. He sent me a copy of his ultrasonic cleaning manual and recommended a product called Citranox®. So far I’ve been very impressed. With once- or twice-fired brass they clean up very quickly. The worst cases I tried were 6 Dashers that had been fired ten times with Varget and never cleaned. The worst fouling was in the bottom of the case around the flash hole. They took longer and I used a more concentrated cleaning solution but they did come out clean. The price is reasonable. I paid $35 a gallon and for once- or twice-fired cases I dilute the cleaner 100 to 1. There is much less chemical reaction with the brass than there is with vinegar. No weird colors, just shiny bright. I even used it with hot water, which speeds up the cleaning process. No need to neutralize. Just rinse in running water and they’re squeaky clean. The cleaner is mostly detergents with a little citric acid. Even at a 1:75 ratio my $35 worth of cleaner will make 75 gallons of solution. It doesn’t seem to be reusable but 75 gallons is a whole lot of solution when I only use about two cups at a time.”

Similar Posts: