MTM Gun Cleaning Patch Catcher — Works Great, Under $10!
Are you tired of making a mess in your gun room and picking up patches off the floor? If you clean at the range, would you like to make life much easier (no hunting for patches on dirty ground)? Then consider the MTM Gun Cleaning Patch Catcher. It is currently just $9.19 on Grafs.com and $9.89 on Amazon.
This handy see-through green container fits on the end of your rifle or shotgun barrel. It works with all patch types and bore sizes and fits virtually all barrel diameters, large and small. Simply slip the MTM Gun Cleaning Patch Catcher over your barrel to contain all the patches pushed out the muzzle. No more mess and stains on your bench/table. When cleaning tasks are done, simply remove the Patch Catcher and dump the contents into the trash. Watch the video to see how the MTM Patch Catcher works. Note how it also retains the solvent spray and/or drips.
One owner explains: “This box straps over the muzzle end of a barrel and keeps the mess completely contained. Excess cleaning solvents collect in the bottom. Patches fall off the jag and are captured as well when the cleaning rod is withdrawn. It also completely contains the splatter burst when a bore brush exits the muzzle of whatever firearm is being cleaned.” (D.J. Bradley)
Here are actual user reviews from verified customers:
“It’s been a long time since I bought something that is just WOW brilliant but this patch catcher is just that. It is so simple, so neat, so clean and so effective. It fits perfectly on all my rifle barrels and catches patches, brush spray and most importantly most of the smells of solvents. I can now clean my rifles in the house without inviting the wrath of my darling wife.” — Emmitt P. (Amazon)
“The MTM Patch Catcher works great! It is easy to adjust to different size barrels, and … all the gunk stays in the trap! Now, no more cleaning up the work bench/floor area after gun cleaning. This trap is a must have! I never knew I needed one of these until I got the MTM one from Graf’s. My buddy had a different brand, and it was hard to use. On his, the trap that holds the dirty patches and ‘juice’ would not stay in place, and some times most of the gunk ended up on the floor.” — Michael T (Grafs.com)
“This little device is more than a patch catcher. It also contains that dirty, smelly spray when a bore bristle exits the barrel. With the [MTM Patch Catcher] top open, it will also catch spray cleaners and lubes when used on small parts.” — TwoBoxer (Amazon)
Similar Posts:
- MTM Gun Cleaning Patch Catcher — Effective and Easy to Use
- New Bore-Tips Foam Bore Swabs for Barrel Cleaning
- Bore-tips Swabs, Chamber Cleaners, and Pull-Through Whips
- Triangle Patches Offer Barrel Cleaning Benefits
- Triangle Cleaning Patch — Innovation That Works
Share the post "MTM Gun Cleaning Patch Catcher — Works Great, Under $10!"
Tags: Bore Brush, Bore Cleaning, MTM, MTM Case-Gard, MTM Cleaning Patch Catcher
This is a handy lil box, but I just place a trash can under the barrel…
Most of my rifles have scope caps but some don’t This gadget is great because when there’s a light breeze blowing at the range the mist from brushing the bore goes right on the scope objective lens. I try my darnedest to keep my lens factory clean, the patch catcher guarantees to keep mist contained.
Previously, I used a thin layer of foam rubber wrapped around the barrel and a 10” or so length of a paper toll rolls tube pushed over the foam rubber.