Using the NP-2DD Reticle — F-TR Champ Danny Biggs Explains

The Nightforce NP-2DD (Double Dot) reticle is popular with both match shooters and long-range varminters. The uncluttered reticle gives you an unobstructed view of the target — and that’s especially important for 1000-yard shooting. You can also use the “gap” between center dot and horizontal lines to judge wind hold-off (this “gap” is 1.1 MOA at 42X and 2.0 MOA at 22X). Some guys use the lower dot for hold-overs when shooting at different distances. At 22X the second dot is 8 MOA lower than the top dot. At full 42X power, the lower dot is 4.3 MOA lower than the top dot.

Clicking Elevation vs. Hold-Over with Double Dots
If you have a Nightforce scope with NP-2DD reticle should you click for elevation changes, or hold-over using the second dot? The answer is: “It depends”. Danny Biggs, multi-time U.S. F-Class F-TR National Champion, offered this advice is our Shooters’ Forum: “There is nothing wrong with [using] the NP-2DD ‘over and under’ dots. Try it, and if it works for you, fine. However [in most situations] I would not bother to use it. Rather, I just click up/down the elevation going from 600 to 1,000 yards.

There is one exception though where I regularly use the lower dot! That is for 1,200-yard shooting — a fad at the Midwest Palma Championships held annually up at Lodi, WI. Here I fully employ [the hold-over method].

Following the 1,000-yard match, I click up 2-3 minutes of elevation depending on the load being used for my 7mm RSAUM, go to 42 power, and use the ‘lower’ dot. For me, the lower (and smaller diameter dot) at 42 power provides a preferable aiming dot for the much diminished size/appearance (at 1200) of the 1,000-yard target face. In this instance, I’m really not too lazy to just ‘click up’. By using the smaller aiming dot I ‘uncover’ the 10/X rings as much as possible as they are obscured by the larger upper dot. [This also allows] a better hold on the rings horizontally for windage purposes.” — Danny