December 6th, 2011

See-Through Expander Riser and Ergo Holder from K&M

K&M PrecisionK&M Precision Shooting Products has two very handy products you may not know about yet. The first, a brilliantly simple device that lets you see your case necks as you expand them, can be used by anyone who necks-up brass (with a compatible expander die body). The second new product is a specialized “fat grip” holder that will make neck-turning easier for those of you out there who use K&M neck-turners.

K&M Expand Mandrel Window Riser
This is a simple threaded extension placed between your expander die body (K&M Expand Iron) and the top of your press. It carries the expander mandrel higher, above the press, and has a cut-out view port so you can see the mandrel as it passes through the neck. Smart, eh? This provides visual feedback during the process of expanding your brass. The patent-pending view riser costs $20.00. Will it expand necks faster, or reduce run-out? We doubt it, but we still would like to have one, if only to eyeball the mandrel to control the neck-entry rate more consistently from case to case.

K&M Expander Riser

Installation: Thread the Expand Mandrel Window Riser into the top of your loading press, then thread the K&M Expand-Iron (Expander Die Body) fully into the top of the window riser and adjust each so you can stroke out the press completely without driving the case mouth into the press adapter. This allows you to view the expanding operation which is typically blind under the press. The riser also eliminates the need for the stop screw in the expander mandrel. LINK: Expand Window Riser Instructions (PDF).


Ergo Holder K&MErgo Holder for K&M Neck-Turning Tool
K&M’s rounded, oversized Ergo Holder lets you hold the K&M neck-turning body more securely (and with less hand cramping). Priced at $35.00, it is an expensive accessory, but we suspect many guys with K&M neck-turners will spring for an Ergo holder just because it gives you a more secure and comfortable grip on the small, square-edged K&M neck-turner.

Customer Feedback Inspired K&M’s Ergo Holder
The folks at K&M told us that their new Ergo Holder was produced in response to customer requests: “[Customers reported that] the neck turner can be hard to hold due to its compact size, especially in high-volume use. The Ergo Holder is machined from aluminum, providing a fatigue-proof grasp of the neck turner. Its mass works like a heat sink to help dissipate heat from the pilot during the turning process. The neck-turner body easily assembles into the Ergo Holder and is held in place with one set screw. The Ergo holder is also designed with the dial indicator in mind and actually makes its use more convenient”.
LINK: Ergo Holder Installation/Use Instructions (PDF).

Credit Forum Member EdLongRange for spotting these new K&M products.

Similar Posts:

Tags: , , , , , ,