Eurooptic vortex burris nightforce sale




teslong borescope digital camera barrel monitor


As an Amazon Associate, this site earns a commission from Amazon sales.









September 10th, 2008

TECH TIP: Humidity Can Change Powder Burn Rates

We’ve all heard the old adage: “Keep your powder dry.” Well, tests by Norma have demonstrated that even normal environmental differences in humidity can affect the way powders burn, at least over the long term. In the July issue of Precision Shooting Magazine, Fred Barker reviews the current Norma and Vihtavuori reloading manuals. Fred notes that, in the Norma manual, Sven-Eric Johansson, head of ballistics at Nexplo/Bofors, presents a very important discussion of water vapor absorption by powder. Johansson shows, with supporting test data, that the same powder will burn at different rates depending on its water content.

Powders Leave the Factory with 0.5 to 1.0% Water Content
Johansson explains that, as manufactured, most powders contain 0.5 to 1% of water by weight. (The relative humidity is “equilibrated” at 40-50% during the manufacturing process to maintain this 0.5-1% moisture content). Importantly, Johansson notes that powder exposed to moist air for a long time will absorb water, causing it to burn at a slower rate. On the other hand, long-term storage in a very dry environment reduces powder moisture content, so the powder burns at a faster rate. In addition, Johansson found that single-base powders are MORE sensitive to relative humidity than are double-base powders (which contain nitroglycerine).

Tests Show Burn Rates Vary with Water Content
Reviewer Fred Barker notes: “Johansson gives twelve (eye-opening) plots of the velocities and pressures obtained on firing several popular cartridges with dehydrated, normal and hydrated Norma powders (from #200 to MRP). He also gives results on loaded .30-06 and .38 Special cartridges stored for 663 to 683 days in relative humidities of 20 and 86%. So Johansson’s advice is to keep powders tightly capped in their factory containers, and to minimize their exposure to dry or humid air.” Confirming Johansson’s findings that storage conditions can alter burn rates, Barker observes: “I have about 10 pounds of WWII 4831 powder that has been stored in dry (about 20% RH) Colorado air for more than 60 years. It now burns about like IMR3031.”

What does this teach us? First, all powders start out with a small, but chemically important, amount of water content. Second, a powder’s water content can change over time, depending on where and how the powder is stored. Third, the water content of your powder DOES make a difference in how it burns, particularly for single-base powders. For example, over a period of time, a powder used (and then recapped) in the hot, dry Southwest will probably behave differently than the same powder used in the humid Southeast.

Reloaders are advised to keep these things in mind. If you want to maintain your powders’ “as manufactured” burn rate, it is wise to head Johannson’s recommendation to keep your powders tightly capped when you’re not actually dispensing charges and avoid exposing your powder to very dry or very humid conditions. The Norma Reloading Manual is available from a variety of sources, including MidwayUSA.com.

Real-World Example — “Dry” H4831sc Runs Hotter

Robert Whitley agrees that the burn rate of the powder varies with the humidity it absorbs. Robert writes: “I had an 8-lb. jug of H4831SC I kept in my detached garage (it can be humid there). 43.5-44.0 gr of this was superbly accurate with the 115 Bergers out of my 6mm Super X. I got tired of bringing it in and out of the garage to my house for reloading so I brought and kept the jug in my reloading room (a dehumidified room in my house) and after a few weeks I loaded up 43.5 gr, went to a match and it shot awful. I could not figure out what was going on until I put that load back over the chronograph and figured out it was going a good bit faster than before and the load was out of the “sweet spot” (42.5 – 43.0 gr was the max I could load and keep it accurate when it was stored in less humid air). I put the jug back in the garage for a few weeks and I now am back to loading 43.5 – 44.0 gr and it shoots great again. I have seen this with other powders too.

If you have two jugs of the same powder, one kept in a room in your house and one somewhere else where it is drier or more humid, don’t expect the two jugs of the same lot of powder to chrono the same with the same charge weights unless and until they are both stored long enough in the same place to equalize again. Been there … done that!”

Do Your Own Test with Sun-Dried Propellants
Johansson studied the effects of humidity variances during long-term storage. Keep in mind that a powder’s water content can change in a much shorter period of time if it is exposed to extreme heat, or if it is used in a very humid environment. You can do your own simple test to show how heat can de-hydrate powder. Throw 100 grains of powder and weigh it. Then put it out in direct sunlight for a full day (shielded from the wind so you don’t lose any kernels). Re-weigh the sun-dried powder. You’ll find it has lost a bit of weight from the water baking out.

Permalink Reloading, Tech Tip 6 Comments »
September 10th, 2008

Places Available for Kelbly's Benchrest School (Sept. 20-21)

Kelbly’s will conduct a Benchrest School at its range in North Lawrence, Ohio, September 20-21st. Past BR school sessions have earned high marks from participants. Jim Kelbly and Greg Walley will be teaching this year. Greg reports: “We still have room for a few more students at the Autumn 2008 benchrest school. (Class size is limited to twelve students.) This class is recommended for the beginner interested in benchrest competition, or the varmint-target shooter looking to optimize his rifles and loading techniques for maximum accuracy. History shows that the weather is usually good at this time of year (rare in these parts!), so we should all have a good time. No need to bring a rifle if you don’t have one, since we will be supplying benchrest rifles, ammunition, rests, wind flags, etc. The cost of the weekend class will be $250. Lunch will be provided each day.”

Kelbly's Benchrest School

Kelbly's Benchrest SchoolTwo-Day Program
The sessions will run eight hours each day, and will be geared for the beginning benchrest shooter who wants to compete in NBRSA or IBS registered group-shooting matches. Saturday’s class will be in a classroom-style setting with Q&A sessions and a slide/video presentation covering many topics:

• Use and maintenance of benchrest target rifles
• Preparation and loading of benchrest grade ammunition using custom loading tools and techniques
• The application of ballistics and load development for optimum accuracy

The Sunday session will cover hands-on shooting, benchrest technique, range condition reading, and range etiquette. Rifles, rests, wind flags, ammunition and rifle cleaning equipment will be provided for the students. Participants can bring their own rifles if desired.

For more info or to register, visit Kelby’s Benchrest School webpage, email greg [at] kelbly.com, or call (330) 683-4674.

Permalink Competition, News No Comments »